Pipe sizes confuse many buyers because the number on the order is not the actual diameter. This guide explains nominal pipe size, schedules and the stainless "S" schedules, with a chart of the most common sizes.
Nominal pipe size (NPS) and DN
NPS is a North American size designation. For NPS 1/8 to 12, the number is only loosely related to the bore; for NPS 14 and above, NPS equals the outside diameter in inches. DN is the metric equivalent used in Europe and elsewhere, so NPS 4 corresponds to DN 100.
The key point is that outside diameter is fixed for each NPS. A 4-inch pipe always has an OD of 114.3 mm, whatever its schedule. This keeps fittings and flanges interchangeable.
What the schedule number means
The schedule sets the wall thickness. A higher schedule means a thicker wall, a smaller bore and a higher pressure rating. Because OD is fixed, increasing the schedule makes the inside diameter smaller.
Schedule 40 and 40S are not always the same
Carbon and alloy steel pipe follows ASME B36.10M. Stainless steel pipe follows ASME B36.19M, which uses the "S" schedules (5S, 10S, 40S, 80S). Up to NPS 10, Schedule 40S equals Schedule 40. For NPS 12, Schedule 40S is 9.53 mm while Schedule 40 is 10.31 mm, so confirm which you need on larger sizes.
Common sizes in millimetres
| NPS | DN | OD | Sch 10S | Sch 40 | Sch 80 | Sch 160 |
|---|---|---|---|---|---|---|
| 1/2" | 15 | 21.3 | 2.11 | 2.77 | 3.73 | 4.78 |
| 3/4" | 20 | 26.7 | 2.11 | 2.87 | 3.91 | 5.56 |
| 1" | 25 | 33.4 | 2.77 | 3.38 | 4.55 | 6.35 |
| 2" | 50 | 60.3 | 2.77 | 3.91 | 5.54 | 8.74 |
| 3" | 80 | 88.9 | 3.05 | 5.49 | 7.62 | 11.13 |
| 4" | 100 | 114.3 | 3.05 | 6.02 | 8.56 | 13.49 |
| 6" | 150 | 168.3 | 3.40 | 7.11 | 10.97 | 18.26 |
| 8" | 200 | 219.1 | 3.76 | 8.18 | 12.70 | 23.01 |
| 10" | 250 | 273.1 | 4.19 | 9.27 | 15.09 | 28.58 |
| 12" | 300 | 323.9 | 4.57 | 10.31 | 17.48 | 33.32 |
The full chart for all sizes, with weights, is on our pipe weight calculator.
Calculating weight from size
Weight per metre in kilograms is (OD − WT) × WT × π × density ÷ 1000, with dimensions in millimetres and density in g/cm³. For carbon steel the constant works out to 0.02466; for austenitic stainless steel it is about 0.0249.
Matching fittings and flanges
Buttweld fittings are ordered in the same schedule as the pipe. Socket weld fittings use pressure classes instead: class 3000 corresponds to Schedule 80 and class 6000 to Schedule 160. Weld neck flanges are bored to match the pipe schedule.
